Jak wykonać posadzkę z żywicy epoksydowej metodą wylewaną? [FILM INSTRUKTAŻOWY]

Introduction

This tutorial will guide you through the process of creating a poured epoxy resin floor using the Techniart Floor System 200 SL. This step-by-step guide is designed for DIY enthusiasts who want to achieve a durable and aesthetically pleasing flooring solution.

Step 1: Assess the Substrate

Evaluate the condition of the floor to determine the necessary preparation steps. Substrates are generally classified into three categories:

1. Very Good: Level and free of defects; only requires manual sanding and priming.
2. Good: Minor imperfections; requires sanding, localized patching, and priming.
3. Damaged: Numerous defects, cracks, and unevenness; requires:
   • Removal of loose or delaminated elements.
   • Sanding (manual or mechanical).
   • Cutting and filling cracks.
   • Patching defects and priming.

Regardless of the substrate condition, ensure the area is dry and free of contaminants before beginning work.

Step 2: Choose Materials and Calculate Quantities

1. Calculate the amount of material needed based on the technical data sheet of the system, then add an extra 10% for safety.
2. Remove loose elements from the substrate.
3. Use a diamond blade to cut all cracks.
4. Sand the surface using a concrete grinding stone.
5. Vacuum the area thoroughly, especially in the cracks, using a narrow nozzle.

Step 3: Prepare the Patching Compound

1. Use TECHNIPLAST 400 RST epoxy resin and dried, fire-sifted quartz sand with a granulation of 0.1-0.4 mm.
2. Mix both components to achieve a paste-like consistency.
3. Fill the cut cracks and patch any defects with the prepared compound.
4. Protect surrounding areas with special tape to avoid contamination.
5. Weigh and mix the ingredients thoroughly, then add quartz sand until a pourable consistency is achieved.
6. Spread the mixture evenly using a stainless steel trowel.
7. Allow the primed surface to set for 12-24 hours.

Step 4: Prepare Materials for the First Layer

1. Measure and mark the work area.
2. Calculate the required materials according to the system data sheet.
3. Weigh the components using a scale and mix them with a low-speed mixer (300 RPM) for about 2 minutes.
4. Transfer to a clean container and mix again for 1 minute.
5. Immediately pour the mixture onto the substrate without leaving it in the container.

Step 5: Apply the Next Layer

1. Use a notched trowel to spread the mixture.
2. Immediately de-air the resin using a spiked roller, applying the mixture in a cross pattern.
3. Ensure you wear spiked shoes during this process.
4. Allow the resin to cure; the floor will achieve full strength after 7 days.

Conclusion

You have now completed the essential steps to create a poured epoxy resin floor using the Techniart Floor System 200 SL. Remember to allow sufficient curing time for optimal durability. For further guidance, keep an eye on future instructional videos, and feel free to share your experiences or questions in the comments. Happy DIY flooring!