Easy Wireless Apple CarPlay installed on OEM Screen of 2015+ Mercedes W205 C-Class

Introduction

This tutorial guides you through the installation process of a wireless Apple CarPlay and Android Auto module into the OEM screen of a 2015+ Mercedes W205 C-Class. This upgrade allows you to enjoy modern smartphone connectivity without the need for a bulky aftermarket screen.

Step 1: Gather Required Tools and Parts

Before starting the installation, ensure you have the necessary tools and components:

• DMP Car Design CarPlay/Android Auto module
• Torx screwdriver
• Trim removal tools
• USB audio converter
• Wi-Fi receiver

Tips

• Make sure to have a clean workspace to keep your components organized.
• Disconnect the car battery before working on electrical components to avoid shorts.

Step 2: Prepare the Module

Configure the module switches according to your vehicle's specifications:

• For a C-Class with an 8.4-inch screen and OEM rear camera:
  • Switches 2, 4, 5, and 6 should be in the up position.
  • Switches 1, 3, and 7 should be in the down position.
  • Leave switch 8 in the up position if using the OEM microphone.

Step 3: Remove the Center Console

1. Use the trim removal tool to pry up the trim around the center console.
2. Carefully lift the trim, pushing on the center button to release it.
3. Remove the two screws securing the center console using the Torx screwdriver.
4. Gently pull the center console up and set it aside.

Step 4: Access the Radio

1. Remove two Torx screws holding the radio in place with the Torx screwdriver.
2. Slide the radio out carefully.
3. Disconnect the large connector by pinching the latch and pulling it out.
4. Remove the satellite radio connection by pressing the clip.

Step 5: Install the New Harness

1. Connect one end of the new harness to the stock harness, securing the latch.
2. Connect the satellite radio connection to the new harness, and plug it back into the radio.
3. Disconnect the blue connection from the display port on the back of the radio by pushing down on the clip.
4. Plug the blue connection from the module into the display port and reconnect the OEM blue connection to the module.

Step 6: Connect the Wi-Fi Receiver and Audio Cable

1. Tuck the Wi-Fi receiver into a suitable location under the dashboard.
2. Route the audio cable to the center armrest.
3. Remove the screws holding down the armrest and slide the cable in.
4. Plug the audio cable into the USB converter and connect it to the USB port in the armrest.

Step 7: Reassemble the Console

1. Reinstall the radio and secure it with the Torx screws.
2. Replace the center console and reattach the trim.
3. Reconnect the car battery.

Step 8: Program the Module

1. Start the car and navigate to the media options.
2. Select USB/Aux to access the module interface.
3. Hold down the designated back button to enter the module settings.
4. Configure the following settings:
   • Language: English
   • Auto phone connect: On
   • Driver position: Left front (if applicable)
   • Wireless CarPlay: On
   • Android Auto: Off (if not using)

Step 9: Connect Your Phone

1. Ensure both Wi-Fi and Bluetooth are enabled on your phone.
2. Enable Siri on your iPhone.
3. In the module interface, select iOS and pair your phone when prompted.
4. Allow CarPlay to connect automatically.

Conclusion

You have successfully installed a wireless CarPlay and Android Auto module into your OEM Mercedes screen. This upgrade provides a cleaner look while enhancing your vehicle's functionality. If you prefer the larger Android screen, you can easily reinstall it later. Enjoy your new connectivity features!