2020 Ducati Streetfighter V4 S | DIY Oil and Filter Change

Introduction

This tutorial guides you through the process of changing the oil and oil filter on a 2020 Ducati Streetfighter V4 S. Regular oil changes are crucial for maintaining engine performance and longevity. This step-by-step guide is applicable to both the Streetfighter and Panigale models.

Step 1: Gather Necessary Tools and Materials

Before starting the oil change, ensure you have all the required tools and materials:

• Tools:

  • 14mm socket or wrench for the drain plug
  • 8mm socket or wrench for the oil filter housing
  • M8 x 1.25 bolts for pulling the filter housing
  • Oil drain pan
  • Towels or rags for cleanup
  • A funnel for pouring new oil

• Materials:

  • Oil change kit (includes oil, filter, seals)
  • Motul 300V Factory Line Road Racing Synthetic 15W50 oil (or preferred oil)
  • High-flow oil filter (or preferred filter)
  • New crush washer for the drain plug

Step 2: Prepare the Motorcycle

• Ensure the bike has been sitting for a few days or hasn't been run overnight. This allows the oil to settle in the pan and filter.
• Clean the drain area around the drain plug to prevent debris from entering the oil system.

Step 3: Drain the Old Oil

1. Loosen the Drain Plug:

   • Use a 14mm socket to crack the drain plug loose.
   • Position the oil drain pan under the drain plug.

2. Remove the Drain Plug:

   • Fully unscrew and remove the drain plug, allowing the old oil to drain completely into the pan.
   • Clean the drain plug and replace the crush washer.

Step 4: Remove the Oil Filter

1. Loosen the Oil Filter Housing:

   • Use an 8mm socket to remove the three bolts securing the oil filter housing.

2. Extract the Housing:

   • Insert M8 bolts into the holes of the oil filter housing and gradually tighten them to pull the housing down. This creates pressure to release the housing.
   • Remove the housing and clean up any oil spills.

3. Replace Old Gaskets:

   • Remove the old gaskets from the housing using a pick tool.
   • Install new gaskets from the oil change kit.

Step 5: Install the New Oil Filter and Reassemble

1. Install the New Oil Filter:

   • Apply a small amount of new oil to the rubber seal on the new filter.
   • Insert the new filter into the housing until it clicks in place.

2. Reattach the Oil Filter Housing:

   • Align the housing and secure it by threading the three bolts back in.
   • Tighten the bolts snugly in a crisscross pattern to ensure even pressure.

3. Reinstall the Drain Plug:

   • Reinstall the drain plug with the new crush washer and tighten it securely.

Step 6: Add New Oil

1. Access the Oil Fill Cap:

   • Remove the oil fill cap and use a funnel to pour in the new oil.

2. Fill with Oil:

   • Add approximately 3 liters of oil, then run the engine for a few minutes to circulate it.
   • After running, turn off the engine and let it sit. Recheck the oil level and add more if necessary.

Conclusion

You've successfully changed the oil and filter on your Ducati Streetfighter V4 S. Regular oil changes improve performance and extend the life of your motorcycle. Make sure to check the oil level again after a short ride and before your next outing. If you're interested, consider adding modifications like frame sliders for added protection. Enjoy your ride!