Замена стоек стабилизатора

Introduction

This tutorial will guide you through the process of replacing the stabilizer links on a Chery Tiggo vehicle using CTR stabilizer links (model CLT-50). This maintenance task is important for vehicle stability and handling. Whether you're a seasoned mechanic or a DIY enthusiast, this step-by-step guide will help you complete the replacement effectively.

Step 1: Gather Necessary Tools and Materials

Before starting the replacement, ensure you have the following tools and materials ready:

• New stabilizer links (CTR CLT-50)
• Wrench set
• Socket set
• Torque wrench
• Jack and jack stands
• Safety glasses
• Gloves

Practical Tips

• Always wear safety gear to protect yourself during the process.
• Ensure your vehicle is on a flat surface before jacking it up.

Step 2: Lift the Vehicle

To access the stabilizer links, you need to lift the vehicle safely.

1. Park the vehicle on a flat surface.
2. Use a jack to lift the front of the vehicle.
3. Secure the vehicle with jack stands to prevent it from falling.

Common Pitfalls

• Never work under a vehicle supported only by a jack; always use jack stands for safety.

Step 3: Locate the Stabilizer Links

Identify the stabilizer links on your Chery Tiggo.

• The stabilizer links are located between the stabilizer bar and the control arms on both sides of the vehicle.
• Inspect both links for wear or damage before removing them.

Step 4: Remove Old Stabilizer Links

To remove the old stabilizer links, follow these steps:

1. Use a wrench to loosen the nuts on both ends of the stabilizer link.
2. Remove the nuts and take out the old link.
3. Check the mounting points for any signs of damage or corrosion.

Practical Advice

• If the nuts are stuck, apply some penetrating oil and let it sit for a few minutes before attempting to loosen them again.

Step 5: Install New Stabilizer Links

Now it's time to install the new stabilizer links.

1. Position the new stabilizer link in place.
2. Thread the nuts onto the link without tightening them fully at this stage.
3. Use a torque wrench to tighten the nuts to the manufacturer’s specifications once all links are in place.

Important Note

• Ensure the stabilizer link is properly aligned to avoid premature wear.

Step 6: Lower the Vehicle

Once the new stabilizer links are installed, lower the vehicle back to the ground.

1. Remove the jack stands carefully.
2. Lower the vehicle using the jack.
3. Remove the jack after the vehicle is stable on the ground.

Conclusion

Replacing the stabilizer links on your Chery Tiggo is a straightforward process that can enhance the vehicle's handling and safety. Always remember to use the correct tools and follow safety precautions. If you encounter any issues during installation, consult a professional mechanic for assistance. Now, you can enjoy smoother rides and better vehicle stability!