Setup a Buffalo WHR-300HP as a repeater. Continued from "Buffalo WHR-300HP as a wireless bridge"

Introduction

This tutorial will guide you through the process of setting up a Buffalo WHR-300HP as a repeater. This device can extend your wireless network, improving connectivity in areas with weak signals. Before proceeding, make sure you have watched the video "Buffalo WHR-300HP as a wireless bridge" for the initial setup.

Step 1: Access the Router's Admin Interface

• Connect your computer to the Buffalo WHR-300HP using an Ethernet cable.
• Open a web browser and enter the router's default IP address, usually 192.168.11.1.
• Log in using the default username and password. These are typically "admin" for both fields, unless changed previously.

Step 2: Configure Wireless Settings

• Navigate to the Wireless settings in the admin interface.
• Set the Wireless Mode to "Repeater."
• Enter the SSID (network name) of the primary router you wish to connect to.
• Choose the same Wireless Channel as the primary router for optimal performance.
• Set the Encryption Type to match the primary network (usually WPA2).

Step 3: Set Up the Repeater Connection

• Go to the Wireless Bridge or Repeater settings.
• Click on Site Survey to find available networks.
• Select your primary router's SSID and click Connect.
• Enter the password for the primary network when prompted.

Step 4: Configure IP Address Settings

• Navigate to the Network settings.
• Select the option to set the router's IP address manually.
• Assign a new IP address to the repeater that is within the same subnet but not conflicting with the primary router (e.g., if the primary is 192.168.1.1, set the repeater to 192.168.1.2).
• Set the Subnet Mask to 255.255.255.0.

Step 5: Save and Reboot

• Click the Save button to apply all changes.
• Reboot the Buffalo WHR-300HP to ensure the new settings take effect.
• Wait for the router to restart completely, which may take a few minutes.

Step 6: Test the Connection

• Once the router has rebooted, disconnect your Ethernet cable and connect to the wireless network created by the repeater.
• Test the internet connection by browsing a website.
• Check the signal strength in areas previously lacking coverage to ensure the repeater is functioning effectively.

Conclusion

You have successfully set up your Buffalo WHR-300HP as a wireless repeater. This setup will help improve your Wi-Fi coverage and connectivity. If you encounter issues, double-check your settings, especially the SSID and passwords. For further enhancements, consider exploring additional features of the router or consulting the user manual for advanced configurations.