Ремонт стиральной машины LG WD-80192N Часть 2 (Замена подшипников, сальника, сборка)

Introduction

This tutorial guides you through the process of replacing the bearings and seal in an LG WD-80192N washing machine, as well as reassembling the unit. These steps will help you restore your washing machine's functionality and extend its lifespan.

Step 1: Disassemble the Washing Machine

• Unplug the machine to ensure safety.
• Remove the top panel by unscrewing the screws located at the back.
• Take off the front panel:
  • Unscrew any visible screws.
  • Detach the door latch and disconnect the wiring harness.
• Remove the drum:
  • Unscrew the bolts securing the drum to the frame.
  • Carefully lift the drum out, paying attention to any attached hoses.

Step 2: Replace the Bearings

• Access the bearings:
  • Once the drum is removed, locate the bearings situated at the rear of the drum.
• Remove old bearings:
  • Gently tap or pry out the old bearings using a flathead screwdriver or bearing puller.
• Install new bearings:
  • Clean the bearing housing to remove any debris.
  • Place the new bearings in position, ensuring they fit snugly.
  • Use a rubber mallet to gently tap them into place if necessary.

Step 3: Replace the Seal

• Remove the old seal:
  • Carefully pull out the old seal from the drum. This may require a bit of force.
• Install the new seal:
  • Align the new seal with the groove on the drum.
  • Press it into place, ensuring it is evenly seated all around.

Step 4: Reassemble the Washing Machine

• Reattach the drum:
  • Lower the drum back into the machine frame.
  • Secure it with the bolts you previously removed.
• Reconnect the front panel:
  • Reattach the door latch and wiring harness.
  • Screw the front panel back into place.
• Reinstall the top panel:
  • Secure it with screws at the back.

Conclusion

You have successfully replaced the bearings and seal in your LG WD-80192N washing machine and reassembled it. Make sure to test the machine by running a short cycle to ensure everything operates smoothly. Regular maintenance can prevent similar issues in the future, so consider checking the condition of components periodically. If you encounter any issues, refer back to the disassembly steps to troubleshoot.