LG Washer Power Button Not Working? Learn How to Fix! [LG Panel Removal & More!]
Table of Contents
Introduction
If your LG top load washer (model WT7305) is not powering on, it can be frustrating. This tutorial will guide you through the steps to diagnose and fix the issue, focusing on replacing the control board, which is often the culprit. With the right tools and parts, you can restore your washer to working condition.
Step 1: Gather Your Tools and Parts
Before you begin the repair, ensure you have all necessary tools and replacement parts.
-
Tools Required:
- Screwdriver (Phillips or flat-head, depending on your washer screws)
- Multimeter (for electrical testing)
-
Replacement Parts:
- PCB Assembly & Display (Part Number EBR86692724 for WT7305CW)
- PCB Assembly Display Only (Part Number EBR85755514)
- PCB Assembly & Display (Part Number EBR86498808 for WT7305CV)
- PCB Assembly Display Only (Part Number EBR85755508)
Step 2: Unplug the Washer
Safety is paramount when working with electrical appliances.
- Disconnect the washer from the power outlet.
- Make sure the water supply is also turned off.
Step 3: Access the Control Panel
To replace the control board, you need to access the control panel.
- Locate the screws holding the control panel in place.
- Remove these screws using your screwdriver.
- Gently lift the control panel to expose the inner components.
Step 4: Remove the Old Control Board
Now that you have access, you can remove the old control board.
- Identify the control board within the panel.
- Disconnect any wiring harnesses attached to the control board by gently pulling them out.
- Remove any screws securing the control board to the panel.
- Carefully take out the old control board.
Step 5: Install the New Control Board
Follow these steps to install the new control board.
- Place the new control board into the control panel.
- Secure the new board with screws.
- Reconnect the wiring harnesses, ensuring they are properly seated.
Step 6: Reassemble the Control Panel
After installing the new control board, it’s time to reassemble the washer.
- Lower the control panel back into position.
- Replace and tighten any screws you removed earlier.
- Ensure everything is secure and in its proper place.
Step 7: Test the Washer
Before you consider the repair complete, it's essential to test your washer.
- Plug the washer back into the power outlet.
- Turn on the water supply.
- Try to power on the washer using the control panel.
- If the washer powers on successfully, run a short cycle to ensure all settings are functioning.
Conclusion
Fixing the power issue in your LG top load washer can often be resolved by replacing the control board. Remember to gather the right tools and parts, and always prioritize safety by unplugging the appliance. If you've followed these steps and the washer still does not work, further diagnosis may be needed, or you might consider contacting a professional repair service. Happy washing!