Replacing The Rear Wheel Bearing on 2015 Jeep Renegade.

Introduction

This tutorial will guide you through the process of replacing the rear driver side wheel bearing on a 2015 Jeep Renegade Trailhawk 2.4L. A faulty wheel bearing can lead to poor handling and increased wear on your vehicle, so it's important to address this issue promptly. By following these detailed steps, you'll be able to perform the replacement with confidence.

Step 1: Prepare Your Vehicle

• Put Vehicle in Brake Service Mode
  • Access the radio menu in your Jeep.
  • Navigate to the settings and select the brake option.
  • Click on "Service Brakes" to initiate brake service mode. This will allow for easier removal of the rear brakes.

Step 2: Remove the Rear Brake Components

• Gather Required Tools

  • Socket set
  • Wrench set
  • Torque wrench
  • Brake cleaner
  • Hammer (if necessary)

• Remove the Wheel

  • Loosen the lug nuts while the vehicle is still on the ground.
  • Jack up the vehicle and secure it with jack stands.
  • Finish removing the lug nuts and take off the wheel.

• Remove the Brake Caliper

  • Locate the caliper bolts and use the appropriate socket to remove them.
  • Carefully lift the caliper off the brake rotor and suspend it using a bungee cord or similar to avoid strain on the brake line.

• Remove the Brake Rotor

  • If the rotor is stuck, gently tap around the edges with a hammer to loosen it.
  • Remove the rotor from the hub.

Step 3: Access the Wheel Bearing

• Remove the Hub Assembly
  • Locate the hub assembly bolts and remove them with a socket.
  • Carefully pull the hub assembly off the axle, exposing the wheel bearing.

Step 4: Replace the Wheel Bearing

• Remove the Old Wheel Bearing

  • Use a bearing puller or a similar tool to extract the old wheel bearing from the hub.
  • Clean the area thoroughly with brake cleaner to remove any debris.

• Install the New Wheel Bearing

  • Insert the new wheel bearing into the hub, ensuring it is seated correctly.
  • Use a bearing installer or a hammer to gently tap the bearing into place.

Step 5: Reassemble the Components

• Reattach the Hub Assembly

  • Position the hub assembly back onto the axle.
  • Secure it by tightening the hub assembly bolts to the manufacturer’s specified torque.

• Reinstall the Brake Rotor and Caliper

  • Place the rotor back onto the hub and ensure it is aligned properly.
  • Reattach the brake caliper and tighten the caliper bolts securely.

• Reattach the Wheel

  • Place the wheel back onto the hub and hand-tighten the lug nuts.
  • Lower the vehicle off the jack stands and tighten the lug nuts to the proper torque specification.

Conclusion

Replacing the rear wheel bearing on your 2015 Jeep Renegade is a manageable task that can enhance your vehicle's performance and safety. Ensure you follow each step carefully and double-check your work for proper torque settings to avoid issues down the road. Once completed, take your Jeep for a test drive to verify that everything is functioning correctly. If you encounter any difficulties, consider consulting a professional mechanic for assistance.