SCHALTZUG WECHSELN am Mountainbike/Trekkingrad - Fahrrad.org

Introduction

In this tutorial, you will learn how to replace the gear cable (Schaltzug) on your mountain bike or trekking bike. This process is essential for maintaining smooth gear shifts and overall bike performance. With the right tools and a bit of patience, you can easily complete this task at home.

Step 1: Gather Necessary Tools

Before you start, make sure you have the following tools:

• New gear cable
• Cable cutters
• Screwdriver (if needed for your bike)
• Allen wrenches (if applicable)
• Bike stand (optional but recommended)

Tip: Ensure that your new cable is the correct length for your bike model.

Step 2: Remove the Old Gear Cable

1. Shift to the Smallest Gear: Start by shifting your bike to the smallest gear. This reduces tension on the cable.
2. Locate the Cable Anchor: Identify where the cable is anchored on the derailleur. This is usually a screw or a clamp.
3. Loosen the Anchor: Use your screwdriver or Allen wrench to loosen the cable anchor. Remove the old cable from the derailleur.
4. Remove Cable Housing: If your bike has cable housing, gently pull it out from the frame and remove it completely.

Common Pitfall: Be careful not to lose any small parts, such as barrel adjusters or cable end caps.

Step 3: Install the New Gear Cable

1. Prepare the New Cable: Take your new gear cable and cut it to the appropriate length if necessary. Thread the end through the derailleur.
2. Attach the Cable: Secure the new cable into the cable anchor and tighten it to hold the cable in place.
3. Reinstall Cable Housing: If applicable, insert the new cable into the cable housing and secure it along the bike frame.

Tip: Ensure the cable runs smoothly through the housing without any twists or bends.

Step 4: Adjust the Tension

1. Check the Cable Tension: Pull the cable taut to ensure it is properly tensioned. Adjust the barrel adjuster on the derailleur if necessary.
2. Test Shifting: Shift through all the gears to ensure smooth operation. Make any additional adjustments to the tension as needed.

Tip: If shifting is not smooth, double-check the cable installation and tension.

Step 5: Final Checks

1. Inspect the Setup: Make sure the cable is properly secured, and there are no frays or loose ends.
2. Take a Test Ride: Go for a short ride to test the performance of the new cable and ensure everything is working correctly.

Conclusion

Replacing the gear cable on your mountain bike or trekking bike is a straightforward task that can greatly enhance your biking experience. By following these steps, you can ensure that your bike shifts smoothly and efficiently. Don’t forget to regularly check and maintain your bike’s components for optimal performance. Happy cycling!