Замена задних колодок Peugeot Partner Tepee

Introduction

This tutorial provides a step-by-step guide on how to replace the rear brake pads on a Peugeot Partner Tepee. Properly maintaining your brake system is crucial for vehicle safety and performance. Following this guide will help you understand the process, tools needed, and tips to avoid common pitfalls.

Step 1: Gather Necessary Tools and Materials

Before starting, ensure you have the following tools and materials:

• New rear brake pads
• Jack and jack stands
• Lug wrench
• Brake cleaner
• C-clamp or brake caliper tool
• Torque wrench
• Gloves and safety goggles

Tip: Always work on a flat surface and ensure your vehicle is stable before performing any maintenance.

Step 2: Remove the Wheel

1. Loosen the lug nuts on the rear wheel using the lug wrench.
2. Use the jack to raise the vehicle and secure it with jack stands.
3. Remove the lug nuts completely and take off the wheel.

Common Pitfall: Never work under a vehicle supported only by a jack. Always use jack stands for safety.

Step 3: Remove the Brake Caliper

1. Locate the caliper bolts on the rear of the brake caliper.
2. Use the appropriate socket to remove these bolts.
3. Carefully slide off the caliper from the brake rotor. Support it with a bungee cord or similar tool to avoid putting stress on the brake line.

Tip: Do not let the caliper hang by the brake line as it can damage the line.

Step 4: Replace the Brake Pads

1. Remove the old brake pads from the caliper bracket.
2. Clean the caliper bracket and rotor with brake cleaner.
3. Install the new brake pads into the caliper bracket, ensuring they are seated properly.

Tip: Compare the new pads with the old ones to ensure proper fit.

Step 5: Compress the Caliper Piston

1. Use a C-clamp or brake caliper tool to compress the caliper piston back into the caliper housing.
2. Place the clamp over the old brake pad and against the caliper piston, then tighten slowly until the piston is fully compressed.

Tip: This step is essential to make room for the new, thicker brake pads.

Step 6: Reinstall the Brake Caliper

1. Carefully slide the caliper back over the new brake pads and onto the rotor.
2. Reinsert and tighten the caliper bolts using the torque wrench to the manufacturer’s specifications.

Tip: Check the vehicle manual for the correct torque settings.

Step 7: Reattach the Wheel

1. Place the wheel back onto the hub.
2. Hand-tighten the lug nuts to hold the wheel in place.
3. Lower the vehicle from the jack stands using the jack.
4. Once the vehicle is on the ground, use the lug wrench to fully tighten the lug nuts in a star pattern.

Conclusion

Replacing the rear brake pads on your Peugeot Partner Tepee is a manageable task that can save you time and expense. Ensure you have all the necessary tools and follow each step carefully. After completing the replacement, it's advisable to pump the brake pedal a few times before driving to ensure proper brake function. Regular maintenance of your brake system enhances safety and prolongs the life of your vehicle. Always consult your vehicle’s manual for specific details and torque settings. Happy driving!