2020 Land Rover Defender 110 snorkel fitting instructions - raised air intake VPLEP0435

Introduction

This tutorial provides step-by-step instructions for fitting a snorkel or raised air intake to the 2020 Land Rover Defender 110, specifically the genuine accessory part number VPLEP0435. This guide is designed to help you install the snorkel without the need to remove the doors, simplifying the process and ensuring a secure fit.

Step 1: Gather Necessary Tools and Materials

Before beginning the installation, ensure you have the following tools and materials ready:

• Snorkel kit (VPLEP0435)
• Screwdriver set (flathead and Phillips)
• Drill with drill bits (appropriate sizes)
• Masking tape
• Measuring tape
• Marker or pencil
• Safety goggles
• Socket set

Tip: Having all tools at hand will streamline the installation process.

Step 2: Prepare the Vehicle

1. Park the Vehicle: Ensure your Land Rover Defender is parked on a flat surface.
2. Clean the Area: Clean the area around the fender where the snorkel will be installed to prevent dirt from entering.
3. Remove Any Obstructions: Take off any parts that may obstruct access to the installation area, such as the wheel arch trim.

Common Pitfall: Forgetting to clean the installation area can lead to dirt contamination inside the vehicle.

Step 3: Mark the Installation Points

1. Consult the Instructions: Review the snorkel fitting instructions included in the kit.
2. Measure and Mark: Use the measuring tape to determine where the snorkel will be mounted. Mark these points clearly with a marker or pencil.
3. Use Masking Tape: Apply masking tape over the marked areas to help with drilling and to protect the paint.

Tip: Double-check measurements to ensure accuracy before drilling.

Step 4: Drill the Holes

1. Choose the Right Drill Bit: Select a drill bit that matches the size specified in the snorkel kit instructions.
2. Drill Carefully: Wear safety goggles and drill the holes at the marked points. Drill slowly to maintain control and accuracy.
3. Deburr the Holes: Remove any sharp edges around the drilled holes using a deburring tool or file.

Safety Note: Always wear safety goggles when drilling to protect your eyes.

Step 5: Fit the Snorkel

1. Align the Snorkel: Position the snorkel over the drilled holes to ensure a proper fit.
2. Secure in Place: Use the screws and brackets provided in the snorkel kit to attach it firmly to the vehicle. Follow the specific order outlined in the instructions.
3. Check for Stability: Ensure the snorkel is securely mounted and does not wobble.

Tip: Tighten screws gradually and avoid over-tightening to prevent damage.

Step 6: Final Checks

1. Inspect the Installation: Review your work to ensure everything is installed correctly and securely.
2. Test the Snorkel: If possible, conduct a brief test drive to ensure the snorkel functions as intended without any air leaks.

Conclusion

Installing a snorkel on the 2020 Land Rover Defender 110 can be a straightforward process if you follow these steps carefully. By preparing adequately and paying attention to detail, you can enhance your vehicle's off-road capabilities effectively. If you encounter any issues or have questions, refer to the original installation manual or consult a professional for assistance. Enjoy your enhanced driving experience!