How to Perform Oil Change 14-19 Chevy Silverado

Introduction

This tutorial provides a step-by-step guide on how to perform an oil change for the 2014-2019 Chevy Silverado, specifically for the 1500 model with a 5.3L V8 engine. Regular oil changes are essential for maintaining engine health and performance, and this guide will equip you with the know-how to do it yourself.

Step 1: Gather Required Tools and Materials

Before starting the oil change, ensure you have the following tools and materials:

• 15mm Wrench
• Oil Filter Wrench
• Brake Parts Cleaner
• Cloth Rags
• Drain Pan
• Funnel
• New Oil Filter
• Engine Oil (check the owner’s manual for type and amount)

Step 2: Prepare Your Vehicle

• Park the vehicle on a level surface.
• Turn off the engine and allow it to cool down for a few minutes.
• Engage the parking brake for safety.

Step 3: Drain the Old Oil

1. Locate the Oil Drain Plug

   • The drain plug is situated at the bottom of the oil pan.

2. Position the Drain Pan

   • Place the drain pan underneath the oil drain plug to catch the old oil.

3. Remove the Drain Plug

   • Use the 15mm wrench to loosen and remove the drain plug. Be cautious as the old oil may still be warm.

4. Allow Oil to Drain

   • Let the oil completely drain into the pan. This may take several minutes.

5. Replace the Drain Plug

   • Once the oil has drained, reinsert the drain plug and tighten it securely.

Step 4: Replace the Oil Filter

1. Locate the Oil Filter

   • The oil filter is usually located on the side of the engine.

2. Remove the Old Oil Filter

   • Use the oil filter wrench to loosen and remove the oil filter. Be prepared for some oil to spill out.

3. Prepare the New Oil Filter

   • Apply a small amount of new engine oil to the rubber gasket of the new oil filter. This helps ensure a good seal.

4. Install the New Oil Filter

   • Screw the new oil filter into place by hand. Ensure it is snug but do not over-tighten.

Step 5: Add New Engine Oil

1. Open the Hood

   • Locate the oil filler cap on top of the engine.

2. Pour in New Oil

   • Using the funnel, pour the new engine oil into the oil filler. Refer to the owner’s manual for the correct oil type and amount.

3. Replace the Oil Filler Cap

   • Securely tighten the oil filler cap once you’ve added the oil.

Step 6: Check Oil Level

1. Start the Engine

   • Run the engine for a few minutes to circulate the new oil.

2. Check the Oil Level

   • After a few minutes, turn off the engine and wait a moment. Use the dipstick to check the oil level.

3. Add More Oil if Necessary

   • If the oil level is below the recommended mark, add more oil as needed.

Step 7: Clean Up

• Dispose of the old oil and filter properly; take them to a recycling center.
• Clean any spills with brake parts cleaner and cloth rags.

Conclusion

Changing the oil in your Chevy Silverado can be done easily with the right tools and steps. Regular oil changes help maintain engine efficiency and prolong its lifespan. Always consult your owner’s manual for specific details regarding oil types and quantities. Now that you’ve completed your oil change, consider marking your calendar for the next one to keep your vehicle running smoothly.