Spyder RT LED headlight install

Introduction

This tutorial provides a detailed step-by-step guide on how to install 9005 LED headlights on your Spyder RT motorcycle. This process is applicable to all years and models of the Spyder RT. Upgrading to LED headlights can enhance your visibility and improve the overall aesthetics of your ride.

Step 1: Gather Necessary Tools and Materials

Before starting the installation, ensure you have the following tools and materials ready:

• 9005 LED headlight bulbs
• Screwdriver (flathead or Phillips depending on your model)
• Pliers (optional)
• Gloves (to prevent oil transfer to the bulbs)

Step 2: Access the Headlight Assembly

To access the headlight assembly, follow these steps:

1. Turn off the motorcycle and remove the key to avoid any electrical issues.
2. Locate the headlight housing, typically found at the front of the Spyder RT.
3. Depending on your model, you may need to remove screws or clips securing the housing. Use the screwdriver to carefully remove these fasteners.

Step 3: Remove the Old Headlight Bulbs

Once the headlight housing is accessible, proceed to remove the old bulbs:

1. Gently twist the old bulb counterclockwise to release it from the socket.
2. Pull the old bulb straight out of the housing.
3. If applicable, disconnect any wiring harnesses attached to the bulb by gently pulling them apart.

Step 4: Install the New 9005 LED Bulbs

Now, install the new 9005 LED bulbs:

1. Take the new LED bulb and carefully align it with the socket.
2. Insert the LED bulb and twist it clockwise until it locks into place.
3. Reconnect any wiring harnesses that were previously disconnected.

Step 5: Reassemble the Headlight Housing

After the new bulbs are securely in place, reassemble the headlight housing:

1. Position the housing back into its original location.
2. Replace any screws or clips you removed earlier to secure the housing.
3. Ensure everything is tightly fastened to prevent any rattling during rides.

Step 6: Test the New Headlights

Before concluding the installation, it’s crucial to test the new headlights:

1. Turn on the motorcycle and activate the headlights.
2. Check both the low and high beam settings to ensure they are functioning correctly.
3. Adjust the angle of the headlights if necessary, following the manufacturer's instructions for alignment.

Conclusion

You have successfully installed 9005 LED headlights on your Spyder RT. This upgrade not only improves visibility but also enhances your motorcycle's appearance. Make sure to regularly check the bulbs and connections to maintain optimal performance. If you encounter any issues, consult your motorcycle's manual or seek assistance from a professional. Enjoy your improved ride!