How to change rear wheel bearing VW GOLF 5 TUTORIAL | AUTODOC

Introduction

This tutorial provides a step-by-step guide on how to change the rear wheel bearing on a VW Golf 5. Replacing a wheel bearing can improve vehicle performance and safety, ensuring smooth driving and reducing noise. Follow these instructions carefully to complete the task efficiently.

Step 1: Gather Required Tools

Before starting, make sure you have the following tools handy:

• Torx socket №M14
• Torx socket №T30
• Torx socket №M18
• Brake cleaner
• Copper grease
• Torque wrench
• Jack and jack stands

Step 2: Prepare the Vehicle

1. Safely lift the car: Use a jack to raise the rear of the vehicle and secure it on jack stands.
2. Remove the wheel: Take off the rear wheel on the side you are working on to access the hub assembly.

Step 3: Remove the Brake Components

1. Uninstall brake caliper:
   • Use the torx socket №T30 to remove the bolts securing the brake caliper.
   • Hang the caliper with a piece of wire to avoid straining the brake line.
2. Remove the brake disc:
   • If necessary, use a hammer to gently tap the brake disc off the hub if it is stuck.

Step 4: Remove the Hub Bearing Cap

1. Take off the hub bearing cap:
   • Carefully pry off the cap to access the hub assembly.

Step 5: Remove the Hub Assembly

1. Uninstall bolts:
   • Use the torx socket №M14 to remove the bolts securing the hub assembly.
   • Use the torx socket №M18 for any additional securing bolts.
2. Take out the hub:
   • Once the bolts are removed, pull the hub assembly straight off the axle.

Step 6: Install the New Wheel Bearing

1. Prepare the new bearing:
   • Clean any debris from the hub area using brake cleaner.
2. Apply copper grease:
   • Treat the brake disc seat with a special copper grease to prevent noise and ensure a smooth fit.
3. Install new bearing:
   • Position the new wheel bearing onto the hub assembly and secure it using the torx bolts previously removed.

Step 7: Reassemble the Brake Components

1. Reattach the brake disc:
   • Align the brake disc onto the hub and ensure it sits correctly.
2. Reconnect the brake caliper:
   • Position the brake caliper back and secure it with torx bolts, ensuring they are tightened properly.

Step 8: Final Steps

1. Reinstall the wheel:
   • Place the wheel back onto the hub and tighten the lug nuts securely.
2. Lower the vehicle:
   • Carefully remove the jack stands and lower the car back to the ground.

Conclusion

You have successfully replaced the rear wheel bearing on your VW Golf 5. Ensure all components are securely fastened and that the vehicle is safe to drive before taking it on the road. If you encounter any issues or if the problem persists, consider seeking professional assistance. Regularly check your vehicle for any signs of wear and maintenance to ensure optimal performance.