VanProject1- Full MaxxFan Installation Video

Introduction

This tutorial provides a comprehensive guide on installing a MaxxFan using a patented mounting kit. While the installation is demonstrated on a Mercedes Sprinter Van, the kit is suitable for any flat-roof van, camper, or RV. By following these steps, you will enhance your vehicle's ventilation, making your travels more comfortable.

Step 1: Gather Necessary Tools and Materials

Before beginning the installation, ensure you have all the required tools and materials ready:

• MaxxFan unit
• Mounting kit
• Drill with appropriate drill bits
• Screwdriver
• Sealant (such as silicone)
• Measuring tape
• Marker or pencil
• Safety goggles
• Ladder (if needed for access)

Step 2: Measure and Mark the Installation Area

• Choose the location on the roof where you want to install the MaxxFan.
• Use a measuring tape to determine the center point for the fan.
• Mark the outline of the fan installation area with a marker or pencil.

Step 3: Cut the Opening in the Roof

• Use a drill to create holes in each corner of the marked area to allow for easier cutting.
• Carefully use a jigsaw to cut along the marked lines, ensuring you maintain a clean edge.
• Remove any debris and check that the opening fits the fan snugly.

Step 4: Prepare the Mounting Kit

• Assemble the mounting kit according to the manufacturer's instructions.
• Ensure all components are intact and ready for installation.

Step 5: Apply Sealant

• Apply a generous amount of sealant around the edges of the cutout in the roof. This will help prevent leaks.
• Be careful not to apply too much; you want a good seal without overflow.

Step 6: Install the MaxxFan

• Position the MaxxFan over the cutout, ensuring it fits securely.
• Align the mounting kit with the fan and the roof.
• Use screws from the mounting kit to secure the fan in place. Tighten carefully to avoid damaging the fan or roof.

Step 7: Finish with Sealant

• Once the fan is secured, apply additional sealant around the edges of the mounting kit to create a waterproof barrier.
• Smooth the sealant with a finger or tool for an even finish.

Step 8: Test the Fan

• Turn on the MaxxFan to ensure it operates correctly.
• Check for any air leaks around the installation area.

Conclusion

You have successfully installed your MaxxFan using the patented mounting kit. This installation will significantly improve ventilation in your van, camper, or RV. For maintenance, periodically check the sealant and ensure that the fan is functioning properly. Enjoy your travels with enhanced comfort!