Замена ремня генератора на Приоре с ГУР или кондиционером

Introduction

This tutorial provides a step-by-step guide on replacing the generator belt on a Lada Priora with a 16-valve engine that features power steering or air conditioning. Proper maintenance of the generator belt is crucial for the vehicle's performance and longevity.

Step 1: Gather Necessary Tools and Materials

Before starting the replacement process, ensure you have the following tools and materials at hand:

• New generator belt
• Wrench set
• Socket set
• Screwdriver
• Pliers
• Torque wrench
• Jack and jack stands (if needed for better access)

Step 2: Prepare the Vehicle

Follow these steps to prepare your vehicle for the belt replacement:

1. Park the car on a flat surface.
2. Turn off the engine and remove the key from the ignition.
3. Allow the engine to cool down.
4. Optionally, lift the front of the vehicle using a jack and secure it with jack stands for better access.

Step 3: Remove the Old Generator Belt

To remove the old generator belt, follow these steps:

1. Locate the generator and identify the tensioner pulley.
2. Use the wrench to loosen the tension on the belt by rotating the tensioner pulley.
3. Carefully slide the belt off the generator and any other pulleys it wraps around.
4. Inspect the old belt for wear and damage, which can indicate the need for replacement.

Step 4: Install the New Generator Belt

Now, it’s time to install the new generator belt:

1. Refer to the vehicle's manual for the correct routing of the new belt.
2. Start by placing the new belt around the crankshaft pulley.
3. Wrap the belt around the generator pulley.
4. Ensure the belt is properly aligned on all pulleys.
5. Use the wrench to adjust the tensioner again, allowing the belt to fit snugly.

Step 5: Check the Tension and Alignment

After installing the new belt, perform the following checks:

1. Make sure the belt is tight but not overly stretched.
2. Check the alignment of the belt on all pulleys to prevent slippage.
3. Adjust the tension if necessary using the tensioner.

Step 6: Reassemble and Test

After ensuring everything is in place, reassemble any components you may have removed:

1. Double-check that all tools are removed from the engine bay.
2. Start the engine and listen for any unusual noises.
3. Observe the belt in operation to ensure it runs smoothly without slipping.

Conclusion

Replacing the generator belt on a Lada Priora is a straightforward process that can enhance your vehicle's reliability. Always remember to check the belt condition regularly and replace it as necessary to avoid engine issues. If you encounter any difficulties or unusual sounds after installation, consult a professional mechanic.