Toyota Rav4 2019-2024 how to replace front and rear brakes

3 min read 1 day ago
Published on Feb 18, 2025 This response is partially generated with the help of AI. It may contain inaccuracies.

Table of Contents

Introduction

In this tutorial, we will guide you through the process of replacing the front and rear brake pads on a 2019 Toyota RAV4. This task is essential for maintaining your vehicle's braking performance and safety. We'll also cover how to engage the electronic parking brake service mode for the rear brakes, ensuring a smooth and efficient replacement.

Step 1: Gather Your Tools and Materials

Before starting, ensure you have the following tools and parts ready:

  • Front brake pads (e.g., Bosch BE2076H)
  • Rear brake pads (e.g., Bosch BE1879H)
  • 14mm socket
  • 11/16 open-end wrench
  • Brake and caliper grease
  • Torque wrench
  • Jack and jack stands
  • Wheel chocks

Tips

  • Always wear safety gear, such as gloves and goggles.
  • Make sure your vehicle is parked on a level surface.

Step 2: Prepare the Vehicle

  1. Park the RAV4 on a flat surface and engage the parking brake.
  2. Loosen the lug nuts on the wheels slightly while the vehicle is still on the ground.
  3. Lift the vehicle using a jack and secure it with jack stands for safety.
  4. Remove the wheels to access the brake components.

Step 3: Replace Front Brake Pads

  1. Remove the caliper bolts using the 14mm socket.
  2. Carefully slide off the caliper and support it with a bungee cord or similar tool to avoid stressing the brake line.
  3. Remove the old brake pads from the caliper bracket.
  4. Install the new brake pads, ensuring they are fitted correctly.
  5. Reposition the caliper over the new pads and secure it by tightening the caliper bolts.

Common Pitfall

  • Ensure the brake pads are oriented correctly to avoid installation issues.

Step 4: Replace Rear Brake Pads

  1. Engage the rear parking brake service mode to retract the electronic parking brake.
    • This can typically be done with an OBD-II scanner or by following specific steps in the vehicle's manual.
  2. Remove the rear caliper bolts using the 14mm socket.
  3. Slide off the rear caliper and support it securely.
  4. Take out the old brake pads and replace them with the new ones.
  5. Reposition the caliper and tighten the caliper bolts.

Note

  • Ensure you disengage the parking brake service mode after completing the installation.

Step 5: Reassemble and Test

  1. Reattach the wheels and hand-tighten the lug nuts.
  2. Lower the vehicle back to the ground.
  3. Tighten the lug nuts in a criss-cross pattern using the torque wrench to the manufacturer’s specifications.
  4. Pump the brake pedal several times to seat the new pads.
  5. Test drive the vehicle at low speeds to ensure proper brake function.

Conclusion

Replacing the brake pads on your 2019 Toyota RAV4 is a straightforward DIY task that enhances your vehicle's safety. Remember to gather all necessary tools, follow each step carefully, and always test your brakes after installation. Regular maintenance not only extends the life of your vehicle but also ensures a safer driving experience. If you encounter any issues or are unsure, consider consulting a professional mechanic. Happy wrenching!