ТЕЧЕТ УНИТАЗ? БАЧОК УНИТАЗА НЕ ДЕРЖИТ ВОДУ? → ПРИЧИНЫ И УСТРАНЕНИЕ ПРОТЕКАНИЯ!

Introduction

Is your toilet leaking? Does the tank not hold water, or is there a continuous trickle after flushing? This tutorial will guide you through the process of identifying and fixing common issues with toilet tanks that lead to leaks, allowing you to resolve the problem quickly and without spending money.

Step 1: Identify the Source of the Leak

To effectively fix the leak, you first need to locate where the water is escaping from.

• Check the Tank: Look for water pooling around the base of the tank.
• Inspect the Connections: Examine the connection between the tank and the bowl. If water is dripping here, it may need tightening or a new washer.
• Examine the Flapper Valve: Lift the tank lid and check if the flapper valve is sealing properly. If it's worn or misaligned, it can cause water to leak into the bowl continuously.

Step 2: Fixing the Flapper Valve

If the flapper valve is the culprit, follow these steps to address the issue.

• Turn Off the Water Supply: Locate the shut-off valve behind the toilet and turn it clockwise to stop the water flow.
• Remove the Flapper:
  • Disconnect the chain from the flush lever.
  • Unclip the flapper from the pegs on the overflow tube.
• Replace the Flapper: Install a new flapper by reversing the removal steps. Ensure it sits properly on the seat.
• Reconnect the Chain: Adjust the chain length to allow the flapper to open and close adequately without being too tight or too loose.

Step 3: Adjusting the Fill Valve

If the tank fills too quickly or doesn’t stop when full, the fill valve may need adjustment.

• Check the Float: Adjust the float arm so that it shuts off the water at the correct level (about 1 inch below the top of the overflow tube).
• Adjust the Fill Valve:
  • If it’s a ball float, bend the arm gently downward.
  • For a cup-style float, locate the adjustment screw and turn it to raise or lower the float level.

Step 4: Inspecting and Tightening Connections

If you notice any leaks at the tank connections:

• Tighten Bolts: Use a wrench to gently tighten the bolts that secure the tank to the bowl, but be careful not to overtighten as this can crack the porcelain.
• Replace Washers: If leaks persist, you may need to replace rubber washers at the connection points to ensure a tight seal.

Conclusion

By following these steps, you can effectively troubleshoot and fix the common issues that cause a toilet tank to leak. Remember to always turn off the water supply before making repairs and to check for leaks after completing your work. If the problem persists after these fixes, consider consulting a plumber for further assistance. This DIY approach can save you time and money while giving you the satisfaction of solving the issue yourself.