Oddprophet Style Tearout Bass | FL Studio Mobile

Introduction

This tutorial will guide you through creating an Oddprophet-style tearout bass sound using FL Studio Mobile. This genre of bass is characterized by its heavy, distorted quality, making it popular in dubstep and electronic music. Whether you're a beginner or looking to refine your skills, this step-by-step guide will help you achieve that signature sound.

Step 1: Set Up Your Project

• Open FL Studio Mobile and create a new project.
• Set your BPM (Beats Per Minute) to around 140, which is typical for dubstep music.
• Create a new channel for your bass sound.

Step 2: Choose Your Synthesizer

• Select a synthesizer plugin from the app’s library. A commonly used plugin for bass sounds is the 3x Oscillator.
• Load the 3x Oscillator or any other synth of your choice.

Step 3: Configure Oscillator Settings

• Set up the oscillators:
  • Use two sawtooth waveforms for a rich sound.
  • Adjust the pitch of one oscillator slightly higher than the other to create a thick, detuned sound.
• Ensure that the third oscillator is set to a sine wave for a deeper sub-bass layer.

Step 4: Shape the Sound with Filters

• Apply a low-pass filter to remove high frequencies:
  • Set the cutoff frequency to around 200-300 Hz.
  • Increase the resonance to add some character to the sound.
• Experiment with the filter envelope to create movement in the sound:
  • Set a fast attack and moderate decay for a punchy effect.

Step 5: Add Distortion

• Incorporate a distortion effect:
  • Use the built-in distortion or overdrive effect in FL Studio Mobile.
  • Adjust the drive level to increase the saturation and grit of the bass sound.
• Be cautious not to overdo it; aim for a balance that enhances the sound without making it muddy.

Step 6: Fine-Tune with Effects

• Add an equalizer (EQ) to shape the frequencies:
  • Boost around 60 Hz for sub-bass presence.
  • Cut any unnecessary mid frequencies to clear up the mix.
• Consider adding reverb or delay for spatial effects, but keep it subtle to maintain the bass's punch.

Step 7: Arrange Your Bass in a Pattern

• Create a new pattern in your project and start programming your bass line:
  • Use short, punchy notes to create that tearout effect.
  • Experiment with note lengths and placements to find a groove that fits your track.

Step 8: Export and Test Your Sound

• Once satisfied with your bass sound, export your project.
• Test the sound in a full mix context to ensure it complements other elements of your track.

Conclusion

You have now created an Oddprophet-style tearout bass sound in FL Studio Mobile. Remember to experiment with different settings and effects to find what works best for your style. Keep practicing and integrating this technique into your productions to refine your sound further. Happy music making!