2020 Hyundai Sonata 1.6L Turbo oil and filter change

Introduction

In this tutorial, we will guide you through the process of changing the oil and filter on a 2020 Hyundai Sonata with a 1.6L Turbo engine. Regular oil changes are crucial for maintaining your vehicle’s performance and longevity. This step-by-step guide will provide you with the necessary tools, parts, and procedures to complete the task efficiently.

Step 1: Gather Your Tools and Supplies

Before you begin, ensure you have the following tools and supplies ready:

• Oil Filter: Genuine Hyundai part number 26350-2M000
• Oil: 5 quarts of the recommended oil (check your owner's manual for specifications)
• Sockets:
  • 17 mm socket for the oil plug
  • 15/16 socket for the cartridge filter housing
  • 10 mm socket for removing the plastic cover
• Oil catch pan
• Funnel
• Rags or paper towels
• Gloves (optional, but recommended)

Step 2: Prepare the Vehicle

1. Park the car on a level surface and turn off the engine.
2. Allow the engine to cool for at least 30 minutes to avoid burns from hot oil.
3. Open the hood and remove the oil filler cap to allow air circulation, which helps the oil drain more effectively.

Step 3: Remove the Plastic Cover

1. Locate the plastic cover over the oil plug.
2. Use the 10 mm socket to remove the two bolts securing the cover.
3. Carefully lift off the cover and set it aside.

Step 4: Drain the Old Oil

1. Position the oil catch pan under the oil pan.
2. Using the 17 mm socket, loosen and remove the oil plug.
3. Allow the old oil to drain completely into the catch pan. This may take a few minutes.

Step 5: Replace the Oil Filter

1. Locate the cartridge oil filter housing.
2. Use the 15/16 socket to remove the filter housing. Be prepared for some residual oil to spill.
3. Remove the old oil filter and replace it with the new one. Ensure the rubber O-ring from the old filter is removed before installing the new filter.
4. Tighten the filter housing securely but do not over-tighten.

Step 6: Reinstall the Oil Plug

1. Once the oil has fully drained, replace the oil plug and tighten it with the 17 mm socket securely.

Step 7: Add New Oil

1. Using a funnel, pour in the new oil. Follow the manufacturer's recommendation, typically around 4.75 to 5 quarts.
2. Check the dipstick to ensure the oil level is at the full mark. If needed, add more oil gradually.

Step 8: Final Checks

1. Reinstall the plastic cover and secure it with the two bolts using the 10 mm socket.
2. Start the engine and let it run for a minute. Check for any leaks around the oil filter and oil plug.
3. Turn off the engine and check the dipstick again to ensure proper oil level.

Conclusion

Changing the oil and filter in your 2020 Hyundai Sonata is a straightforward process that can enhance your vehicle's performance and lifespan. Always remember to dispose of the old oil and filter properly at a recycling center. Regular maintenance like this can save you money and keep your car running smoothly. For your next oil change, just follow these steps, and you'll be ready to go!