ENGINE Oil Change - Step-by-Step Honda Accord (2013-2017)

3 min read 4 months ago
Published on Aug 16, 2024 This response is partially generated with the help of AI. It may contain inaccuracies.

Table of Contents

Introduction

This tutorial provides a step-by-step guide to changing the engine oil in a 2013-2017 Honda Accord. Regular oil changes are crucial for maintaining engine performance and longevity. This guide is also applicable to Honda CR-V models and Acura TLX 2.4L.

Step 1: Gather Necessary Materials

Before beginning the oil change, gather all required materials:

  • 0W-20 synthetic oil
  • Oil filter
  • Oil filter wrench
  • Socket wrench set
  • Drain pan
  • Funnel
  • Rags or paper towels
  • Safety gloves
  • Jack and jack stands (or ramps)

Step 2: Prepare the Vehicle

  • Ensure the vehicle is parked on a level surface.
  • Turn off the engine and let it cool for about 30 minutes.
  • Engage the parking brake.
  • Use the jack to lift the front of the vehicle and secure it with jack stands.

Step 3: Drain Old Oil

  • Place the drain pan under the oil pan.
  • Locate the oil drain plug at the bottom of the oil pan.
  • Use a socket wrench to remove the drain plug and allow the old oil to fully drain out into the pan.
  • Once drained, replace the drain plug and tighten it securely.

Step 4: Replace Oil Filter

  • Locate the oil filter, which is typically situated near the oil pan.
  • Use an oil filter wrench to loosen and remove the old oil filter.
  • Before installing the new filter, apply a small amount of fresh oil to the rubber gasket of the new filter. This helps ensure a proper seal.
  • Install the new oil filter by hand, tightening it until snug.

Step 5: Add New Oil

  • Remove the oil filler cap on top of the engine.
  • Using a funnel, pour in the new 0W-20 synthetic oil. The engine typically requires about 4.5 quarts, but check your owner’s manual for specific capacity.
  • Replace the oil filler cap after adding the oil.

Step 6: Check Oil Level

  • Start the engine and let it run for a minute to circulate the new oil.
  • Turn off the engine and wait a minute.
  • Use the dipstick to check the oil level. Remove the dipstick, wipe it clean, reinsert it, and then pull it out again to check the level.
  • If the oil level is low, add more oil as needed.

Step 7: Dispose of Old Oil and Filter

  • Properly dispose of the old oil and oil filter at a recycling center or an auto parts store that accepts used oil.

Conclusion

Changing the oil in your Honda Accord is a straightforward process that can be done at home with the right tools and materials. Regular oil changes help maintain engine efficiency and can prevent costly repairs down the line. Remember to check your owner's manual for specific details related to your vehicle model. After completing the oil change, consider scheduling the next oil change based on your driving habits and oil type used.