How To Remove Your Model 3 Rear Seats - TESBROS

Introduction

This tutorial provides step-by-step instructions for removing the rear seats of a Tesla Model 3. Whether you're looking to upgrade your interior or need to access components underneath the seats, this guide will take you through the entire process clearly and safely.

Chapter 1: Why You Can't Remove the Front Seats

• Removing the front seats is complicated due to:
  • Two T45 bolts secured with Loctite, making them difficult to loosen.
  • Requires special tools.
• Focus on removing the rear seats instead, as they are simpler to handle.

Chapter 2: Warning When Moving the Front Seats Forward

• Ensure the front seats are pushed all the way forward for better access to the rear seats.
• Be cautious not to hit the mirrors during this process to avoid breaking them.

Chapter 3: Remove Bench Seat

1. Locate the levers on both sides of the bench seat.
2. Pull both levers simultaneously to release the bench.
3. Before removing, disconnect two connectors:
   • Gently pry up the first connector.
   • Push down on the second connector to release it.
4. Note:
   • Be careful around the 12-volt connection and high voltage cables.

Chapter 4: Remove Side Panels

1. Identify the hooks and clips securing the side panels.
2. Pull down from the bottom and up from the top to release the side panel.
3. Repeat the process on the opposite side.
4. Be careful not to damage the clips during reinstallation.

Chapter 5: Remove Left Single Seat

1. Access the two 13mm bolts using a ratchet.
2. Hand loosen the bolts first before fully removing them.
3. Disconnect the cable by pulling from the connector, not the wires.

Chapter 6: Remove Center Console Areas

1. Use a T45 bit to loosen the bolts in the center console area.
2. Use a trim tool to pry out the plastic clip between the metal bars.
3. Once loose, remove the clip and pull the assembly out.

Chapter 7: Remove Right Double Seat

1. Remove the seat belt bolt using a 15mm socket.
2. Loosen the two 13mm bolts as done previously.
3. Once bolts are removed, gently pull the seat towards you to detach it.

Chapter 8: Remove Headrest for Middle Seat

1. Use a small flathead screwdriver to push down into the slot on the headrest.
2. This action will loosen the headrest, allowing it to be removed easily.

Conclusion

You have now successfully removed the rear seats from your Tesla Model 3. To reinstall, reverse the steps outlined above. Always be cautious with electrical connections and take care when handling the seats to avoid damage. If you have any questions or need further assistance, feel free to reach out in the comments.