Замена задних тормозных колодок Пежо 406

Introduction

In this tutorial, we'll walk you through the process of replacing the rear brake pads on a Peugeot 406 HDI 2.0 from 2002. This task is essential for maintaining your vehicle's safety and performance. If you hear squeaking sounds when braking, it may indicate worn-out pads that need immediate attention.

Step 1: Gather Necessary Tools and Materials

Before starting the replacement, ensure you have the following items:

• New brake pads
• Brake caliper tool or C-clamp
• Socket set (including a 13mm socket)
• Brake cleaner
• Torque wrench
• Jack and jack stands
• Safety goggles and gloves

Step 2: Prepare the Vehicle

1. Park on a Flat Surface: Ensure the vehicle is parked on a level surface to prevent it from rolling.
2. Engage the Handbrake: This secures the car in place while you work.
3. Loosen Wheel Nuts: Use a lug wrench to slightly loosen the wheel nuts on the rear tires before lifting the vehicle.

Step 3: Raise the Vehicle

1. Jack Up the Rear: Position the jack under the rear jacking points and lift the vehicle.
2. Secure with Jack Stands: Place jack stands under the vehicle to ensure it remains stable while you work.

Step 4: Remove the Rear Wheel

1. Completely Remove the Lug Nuts: Once the vehicle is lifted and secure, remove the wheel nuts and take off the rear wheel.
2. Inspect the Brake Assembly: Check for any visible signs of wear or damage.

Step 5: Remove the Brake Caliper

1. Locate the Caliper Bolts: These are typically found on the rear side of the caliper.
2. Use the 13mm Socket: Remove the bolts securing the caliper to the bracket.
3. Support the Caliper: Hang the caliper using a bungee cord or similar tool to avoid stress on the brake line.

Step 6: Replace the Brake Pads

1. Remove Old Brake Pads: Slide the old pads out of the caliper bracket.
2. Clean the Brake Area: Use brake cleaner to clean the caliper and the bracket.
3. Install New Brake Pads: Slide the new pads into the caliper bracket. Ensure they fit snugly.

Step 7: Compress the Caliper Piston

1. Use a Brake Caliper Tool: Alternatively, a C-clamp can also be used. Place it over the caliper and slowly compress the piston back into the caliper.
2. Check the Piston: Ensure it’s fully retracted to fit over the new pads.

Step 8: Reassemble the Brake Caliper

1. Position the Caliper: Align it over the new pads.
2. Reinsert Caliper Bolts: Tighten the bolts to secure the caliper in place.
3. Torque Specifications: Refer to your vehicle manual for the specified torque for the caliper bolts.

Step 9: Reinstall the Wheel

1. Place the Wheel Back: Align the wheel with the hub and hand-tighten the lug nuts.
2. Lower the Vehicle: Carefully remove the jack stands and lower the vehicle back to the ground.
3. Tighten Lug Nuts: Use a torque wrench to tighten the lug nuts to the manufacturer's specifications.

Conclusion

Replacing the rear brake pads on a Peugeot 406 is a straightforward process that can be completed with some basic tools and careful attention. Regular maintenance is vital for your safety on the road. If you notice any unusual sounds or feel a decrease in braking performance, don’t hesitate to check your brakes. After completing the replacement, consider taking your vehicle for a short test drive to ensure everything is functioning properly.