How to Fix Frigidaire Side by Side Refrigerator Flashing H1 Error Code | Model FFHS2611PFCA

Introduction

If your Frigidaire Side by Side Refrigerator, model FFHS2611PFCA, is flashing the "H1" error code and the refrigerator section is warm, it indicates that one of the sections is not cooling properly. This guide will walk you through diagnosing the issue and replacing the air damper assembly, which is often the culprit.

Step 1: Unplug the Refrigerator

• Before starting any repairs, ensure your safety by unplugging the refrigerator. This prevents electrical shock and accidental operation during the repair process.

Step 2: Access the Air Damper Assembly

• Locate the damper: The air damper is typically located between the refrigerator and freezer compartments.
• Remove the cover: Use a screwdriver to remove screws holding the cover in place. Gently pull the cover off to expose the air damper assembly.

Step 3: Inspect the Air Damper

• Check for obstructions: Ensure that there are no ice or debris blocking the damper from opening.
• Test the damper: If the damper does not open when activated, it is likely defective and needs to be replaced.

Step 4: Remove the Old Air Damper Assembly

• Disconnect wiring: Carefully unplug the electrical connector from the damper.
• Unscrew the assembly: Remove any screws holding the air damper assembly in place.
• Take out the damper: Pull the assembly out gently.

Step 5: Install the New Air Damper Assembly

• Insert the new damper: Place the new air damper assembly in the same position as the old one.
• Secure the assembly: Reattach any screws to hold the new damper in place.
• Reconnect wiring: Plug the electrical connector back into the new damper.

Step 6: Reassemble and Test

• Replace the cover: Put the cover back over the damper and secure it with screws.
• Plug in the refrigerator: Restore power to the appliance.
• Monitor temperature: Check the refrigerator section after a few hours to ensure it is cooling properly and the "H1" error code is resolved.

Conclusion

Replacing the air damper assembly can effectively resolve the "H1" error code in your Frigidaire refrigerator. By following these steps, you can restore proper cooling functionality and extend the life of your appliance. If the problem persists after replacing the damper, further troubleshooting may be necessary, or you may need to consult a professional technician.