✅ How To Get Yellow Jackets & Wasps Out of House Siding Without Getting Stung

Introduction

This tutorial will guide you through the process of safely removing yellow jackets and wasps from your house siding without getting stung. Using non-repellent insecticides is crucial for effectively eliminating the entire colony. Follow these steps to tackle the problem efficiently.

Step 1: Prepare for Treatment

Before you begin, make sure to gather your materials and protect yourself.

Gather Your Supplies

• Non-repellent insecticide spray (e.g., Spectre PS Aerosol Spray)
• Insecticide dust (e.g., D-Fense Dust)
• Diatomaceous Earth Powder Duster
• Insect-resistant expanding foam
• Personal protective gear (e.g., gloves, long sleeves, face shield or sandblast hood)

Tips for Safety

• Wait until dusk when yellow jackets are most likely to be home.
• Wear full protective gear to prevent stings.

Step 2: Apply Insecticide Spray

Start by treating the areas where you see yellow jackets entering or exiting.

Application Process

1. Locate the Nest: Identify the entry points in your siding or walls.
2. Spray the Insecticide:
   • Use the aerosol spray to target the entry points directly.
   • Allow the spray to dry before proceeding to the next step.
3. Observe Activity: Look for yellow jackets flying around to gauge the effectiveness of the spray.

Practical Advice

• You may not be able to reach all areas where yellow jackets are hiding, so additional treatment methods will be necessary.

Step 3: Use Insecticide Dust

For areas that are hard to reach, dusting is an effective way to eliminate remaining yellow jackets.

Dusting Process

1. Prepare the Duster: Fill the Diatomaceous Earth Powder Duster with D-Fense Dust.
2. Apply the Dust:
   • Insert the nozzle into the cracks or gaps where yellow jackets may be hiding.
   • Puff the dust into these areas thoroughly.
3. Check for Effectiveness: Monitor the area over the next few days for signs of yellow jacket activity.

Common Pitfalls to Avoid

• Ensure you use non-repellent insecticides, as repellent types may cause yellow jackets to avoid the area temporarily, which is not effective for long-term removal.

Step 4: Monitor Activity and Seal Entry Points

After treatment, watch for any ongoing activity from yellow jackets.

Monitoring Process

• Check the treated areas daily for a week.
• Look for decreased activity, such as fewer yellow jackets flying around or crawling on the ground.

Sealing Entry Points

Once you’re confident that the yellow jackets are gone:

1. Seal Cracks and Gaps: Use insect-resistant expanding foam to seal any entry points.
2. Prevent Future Infestations: Regularly inspect your home for potential entry points to avoid future problems.

Conclusion

By following these steps, you can effectively remove yellow jackets and wasps from your house siding without getting stung. Remember to use non-repellent insecticides for the best results and to monitor the treated areas before sealing them up. If you notice any further activity, you may need to repeat the treatment process. Stay safe and proactive in preventing future infestations!