Ремонт степлера своими руками. Бьёт по две скобы...

Introduction

This tutorial will guide you through repairing a construction stapler that is malfunctioning by firing two staples at once. You'll learn how to disassemble the stapler, identify the issue, and fix it yourself, ensuring your tool operates smoothly again.

Step 1: Gather Your Tools

Before starting the repair, make sure you have the following tools ready:

• Screwdriver (flathead or Phillips, depending on your stapler)
• Pliers
• Clean cloth
• Lubricant (like machine oil)
• Replacement parts (if necessary)

Step 2: Disassemble the Stapler

To access the internal components of the stapler, follow these sub-steps:

1. Remove the loading magazine: This is typically found at the back of the stapler. Slide it out gently.
2. Unscrew the casing: Use the screwdriver to remove screws from the body of the stapler. Keep the screws in a safe place.
3. Carefully lift the casing: Once unscrewed, gently lift the casing to avoid damaging any internal mechanisms.

Step 3: Identify the Problem

With the stapler disassembled, inspect the following components:

• Staple guide: Check for blockages or misalignments that could cause double firing.
• Spring mechanism: Ensure the spring is functioning properly and is not damaged.
• Trigger assembly: Test if the trigger is sticking or not returning to its original position.

Step 4: Fix the Issue

Depending on what you find in the previous step, you may need to:

• Realign the staple guide: If it’s misaligned, adjust it back into the correct position.
• Replace the spring: If the spring is broken, replace it with a new one. Make sure it fits properly.
• Lubricate moving parts: Apply a small amount of lubricant to the trigger and other moving components to ensure smooth operation.

Step 5: Reassemble the Stapler

Once the issue is resolved, reassemble the stapler:

1. Place the casing back: Align it carefully and ensure no wires or small parts are pinched.
2. Screw the casing securely: Tighten the screws you removed earlier.
3. Reinsert the loading magazine: Ensure it clicks into place properly.

Step 6: Test the Stapler

After reassembly, follow these steps to test your stapler:

• Load it with staples.
• Perform a few test firings on scrap material.
• Observe if it still fires two staples at once or if it operates correctly now.

Conclusion

By following these steps, you can successfully repair a construction stapler that fires two staples at once. Regular maintenance and timely repairs can extend the life of your tools. If issues persist, consider consulting a professional or replacing the stapler. Happy fixing!