Falcon Player 2.x Setup EP5 - Master/Remote (2018)

Introduction

This tutorial guides you through the process of setting up a master/remote configuration in Falcon Player (FPP) version 2.x. This advanced feature allows multiple Raspberry Pi devices to sync their operations, which is particularly useful for large-scale lighting shows, managing video playback, or when network limitations exist.

Step 1: Prepare Your Hardware

• Ensure you have at least two Raspberry Pi devices set up with Falcon Player installed.
• Connect these devices to your network, either via Ethernet or Wi-Fi.
• Verify that both Pis are powered and functioning correctly.

Step 2: Configure the Master Pi

• Access the Falcon Player interface on your master Raspberry Pi.
• Navigate to the Settings or Configuration section.
• Set up your show and any necessary playlists on this master device.
• Under the Master/Remote settings, enable the master mode:
  • Go to Master/Remote settings.
  • Select the option to operate as a Master.

Step 3: Set Up the Remote Pi

• Open the Falcon Player interface on your remote Raspberry Pi.
• In the Master/Remote settings, select the option to operate as a Remote.
• Enter the IP address of the master Pi to establish the connection.
• Ensure that the remote Pi is set to receive data from the master.

Step 4: Syncing Configuration

• On the master Pi, navigate back to the Master/Remote settings.
• You may need to configure the sync options to ensure that both devices share the same playlists, sequences, and settings.
• Test the connection by triggering a sequence from the master Pi and confirming it plays on the remote Pi.

Step 5: Troubleshooting Common Issues

• If the remote Pi does not connect:
  • Check the network connection for both devices.
  • Ensure the IP address entered is correct.
• If syncing issues arise:
  • Verify settings on both devices to ensure they are correctly configured for master and remote functions.
  • Consult the Falcon Player forums for additional support and community advice.

Conclusion

Setting up a master/remote configuration in Falcon Player enhances your lighting display's flexibility and efficiency. By following these steps, you can synchronize multiple Raspberry Pi devices to create dynamic and engaging shows. For further learning, consider exploring additional resources on computer-controlled lighting or joining relevant online forums for community support.