Ford s max Замена задних колодок с электрическим ручником

Introduction

This tutorial explains how to replace the rear brake pads on a Ford S-Max equipped with an electric parking brake. Understanding this process is essential for maintaining your vehicle's braking system and ensuring safety. The steps outlined here will guide you through the procedure, making it easier and more efficient.

Step 1: Prepare Your Tools and Vehicle

Before starting the replacement, gather the necessary tools and prepare your vehicle.

• Tools Required:

  • Socket set
  • Torque wrench
  • Brake pad spreader or C-clamp
  • Screwdrivers (flathead and Phillips)
  • Pliers
  • Vehicle jack and stands
  • Brake cleaner
  • New brake pads

• Prepare Your Vehicle:

  • Park the vehicle on a level surface.
  • Engage the electric parking brake.
  • Disconnect the battery to avoid any electrical issues.

Step 2: Access the Rear Brake Components

To access the rear brake pads, you'll need to remove the wheel and brake caliper.

1. Remove the Wheel:

   • Loosen the lug nuts slightly before lifting the vehicle.
   • Use a jack to raise the vehicle and secure it with stands.
   • Remove the lug nuts completely and take off the wheel.

2. Remove the Brake Caliper:

   • Locate the caliper bolts on the rear of the caliper.
   • Use the socket set to remove these bolts.
   • Carefully slide the caliper off the brake rotor. Support it with a bungee cord or a piece of wire to avoid stressing the brake line.

Step 3: Retract the Electric Parking Brake

With the caliper removed, you need to retract the electric parking brake to make room for the new pads.

• Using a Diagnostic Tool:

  • Connect an OBD-II scanner that supports electronic parking brake functions.
  • Follow the tool's instructions to retract the parking brake.

• Manual Method (if applicable):

  • Some models may allow manual retraction. Check your owner's manual for specific instructions.

Step 4: Replace the Brake Pads

Now you can replace the old brake pads with new ones.

1. Remove Old Pads:

   • Slide out the old brake pads from the caliper bracket.
   • Inspect the caliper for wear or damage.

2. Install New Pads:

   • Apply a thin layer of brake grease to the back of the new pads.
   • Slide the new pads into the caliper bracket.

Step 5: Reassemble the Brake Components

After installing the new pads, reassemble the brake system.

1. Reattach the Caliper:

   • Position the caliper over the new pads.
   • Secure it with the caliper bolts and tighten them to the manufacturer's specifications using a torque wrench.

2. Reinstall the Wheel:

   • Place the wheel back onto the hub.
   • Hand-tighten the lug nuts before lowering the vehicle.
   • Once on the ground, use the torque wrench to fully tighten the lug nuts.

Step 6: Test the Electric Parking Brake

After reassembly, it's crucial to test the electric parking brake.

• Reconnect the Battery:

  • Reconnect the battery terminals.

• Test the Brake Function:

  • Turn on the ignition and activate the electric parking brake.
  • Ensure it engages and disengages properly.

Conclusion

Replacing the rear brake pads on a Ford S-Max with an electric parking brake can be a straightforward task if you follow these steps carefully. Always ensure your tools are within reach and double-check your work before driving. If you're not comfortable with any step, consider consulting a professional mechanic. Regular maintenance of your braking system is key to safe driving.