How to Replace Rear Wheel Bearing & Hub Assembly 2014-2022 Jeep Cherokee

Introduction

This tutorial will guide you through the process of replacing the rear wheel bearing and hub assembly on a 2014-2022 Jeep Cherokee. A worn wheel bearing can cause noise, vibrations, and unsafe driving conditions, so it’s vital to replace it promptly. This guide provides step-by-step instructions to help you complete this repair safely and efficiently.

Step 1: Gather Necessary Tools and Materials

Before starting the repair, ensure you have all the required tools and materials:

• Pry Bar
• 10mm Socket
• 19mm Socket
• 36mm Socket
• Brake Caliper Hanger
• Pliers
• E14 Socket
• T55 Torx Socket
• Torque Wrench
• Anti-Seize Grease
• Gloves
• Safety Glasses
• 5mm Hex Socket
• Floor Jack
• Hammer
• Punch

Step 2: Safety First

• Wear safety glasses and gloves to protect yourself during the repair.
• Ensure the vehicle is on a flat surface and engage the parking brake.
• Use a floor jack to lift the vehicle and securely place it on jack stands.

Step 3: Remove the Rear Wheel

1. Use a 19mm socket to loosen the lug nuts on the rear wheel.
2. Remove the wheel and set it aside.

Step 4: Remove the Brake Caliper

1. Use a 10mm socket to remove the bolts securing the brake caliper.
2. Hang the caliper using a brake caliper hanger to prevent stress on the brake line.

Step 5: Remove the Brake Rotor

1. If necessary, use a hammer and punch to tap out the retaining clips or screws.
2. Slide the brake rotor off the hub.

Step 6: Remove the Hub Assembly

1. Remove any dirt or debris around the hub.
2. Use the E14 socket to remove the bolts securing the hub assembly.
3. If the hub is stuck, gently tap it with a hammer to loosen it.

Step 7: Install the New Wheel Bearing and Hub Assembly

1. Apply anti-seize grease to the mating surface.
2. Align the new hub assembly with the mounting points.
3. Install and tighten the hub assembly bolts using the torque wrench to the manufacturer's specifications.

Step 8: Reassemble the Brake Components

1. Place the brake rotor back onto the hub.
2. Reinstall the brake caliper and secure with the 10mm bolts.
3. Ensure everything is tightened appropriately.

Step 9: Reinstall the Wheel

1. Place the wheel back onto the hub.
2. Hand-tighten the lug nuts with a 19mm socket.
3. Lower the vehicle and fully tighten the lug nuts in a crisscross pattern to ensure even pressure.

Conclusion

Replacing the rear wheel bearing and hub assembly on your Jeep Cherokee is a manageable task with the right tools and steps. Always prioritize safety and ensure all components are properly secured. If you encounter any issues, consider consulting a professional mechanic. With your new hub assembly in place, you can enjoy a smoother and safer driving experience.